Linker Directives   mikroBasic PRO for PIC Language Reference > Directives >

Linker Directives

mikroBasic PRO for PIC uses internal algorithm to distribute objects within memory. If you need to have a variable or a routine at the specific predefined address, use the linker directives absolute and org.

Directive absolute

Directive absolute specifies the starting address in RAM for a variable. If the variable is multi-byte, higher bytes will be stored at the consecutive locations.

Directive absolute is appended to declaration of a variable:

' Variable x will occupy 1 word (16 bits) at address 0x32
dim x as word absolute 0x32

' Variable y will occupy 2 words at addresses 0x34 and 0x36
dim y as longint absolute 0x34

Be careful when using absolute directive, as you may overlap two variables by accident. For example:

dim  i as word absolute 0x42
' Variable i will occupy 1 word at address 0x42;

dim jj as longint absolute 0x40
' Variable will occupy 2 words at 0x40 and 0x42; thus,
' changing i changes jj at the same time and vice versa

Directive org

Directive org specifies the starting address of a constant or a routine in ROM. It is appended to the constant or a routine declaration.

To place a constant array in Flash memory, write the following :

' Constant array MONTHS will be placed starting from the address 0x800
const MONTHS as byte[12] = (31,28,31,30,31,30,31,31,30,31,30,31) org 0x800

If you want to place simple type constant into Flash memory, instead of following declaration:

const SimpleConstant as byte = 0xAA org 0x2000

use an array consisting of single element :

const SimpleConstant as byte[1] = (0xAA) org 0x800

In first case, compiler will recognize your attempt, but in order to save Flash space, and boost performance, it will automatically replace all instances of this constant in code with it's literal value.
In the second case your constant will be placed in Flash in the exact location specified.

To place a routine on a specific address in Flash memory you should write the following :

sub procedure proc(dim par as word) org 0x200
' Procedure will start at the address 0x200;
...
end sub

org directive can be used with main routine too. For example:

program Led_Blinking 


main: org 0x800             ' main procedure starts at 0x800
...
end

Directive orgall

Use the orgall directive to specify the address above which all routines and constants will be placed. Example:

main:
  orgall(0x200) ' All the routines, constants in main program will be above the address 0x200
  ...
end.